Remko PGT 30 User Manual

REMKO - powerful like a bear. REMKO PGT Propane gas heater Edition GB – R02 Operation Technology Spare Parts

10 Wiring Diagram PGT 100 / 100 E STB4 3230 / 1~ 50Hz PEA3A2A1B6B4B5312RTS8ARSZIZTKLMVpgt_30_60.prt M10 M N L1 N L1 3564 356 1 297888B1~HS

11 Series PGT 30 / 30 E PGT 60 / 60 E PGT 100 / 100 E Rated heat output kW 26 55 100 Heating capacity kW 10 – 26 25 – 55 50 – 10

12 Exploded View PGT 30 / 30 E We reserve the right to make changes to dimensions and design in the interest of technical progress.

13 Spare Part List PGT 30 / 30 E When ordering spare parts, please indicate ref. no. and machine no. (see type plate)! No. Description Ref. No. 1 t

14 Exploded View PGT 60 / 60 E We reserve the right to make changes to dimensions and design in the interest of technical progress.

15 Spare Part List PGT 60 / 60 E No. Description Ref. No. 1 transport handle 1101142 2 outside casing PGT 60 1101420 2a outside casing PGT 60 E (s

16 Exploded View PGT 100 / 100 E 13141518 17 16231124226251921 20844 45892956459505355547515258494743333134 35 36 373230224139404611a/b103857292856222

17 Spare Part List PGT 100 / 100 E No. Description Ref. No. No. Description Ref. No. 1 transport handle 1101680 29 gas supply pipe R/D 11016

18 Troubleshooting – Unit doesn’t start – Unit stops during operation – Fan blows but gas supply is blocked or the flame does not ignite – Gas

19 Adjustments or maintenance work may only be performed by authorised personnel! Maintenance Log Clean unit -surface- Clean unit -interior- Clean fan

REMKO GmbH & Co. KG Klima- und Wärmetechnik 32791 Lage, Im Seelenkamp 12 32777 Lage, PO Box 1827 Phone +49 5232 606-0 Fax +49 5232 606-260 E-ma

3 Contents Page Safety Instructions 4 Description of the Unit 4 General Instructions 5 Before Starting 5 Gas Supply 6 Starting 7 Unit Shut Down

4 Description of the Unit The unit is directly fired with liquid gas in a gaseous state. The unit works without an exhaust connection and has been de

5 If work is performed on the gas supply hose or if the gas cylinder is replaced, all stop valves must be closed and nothing which can potentially ign

6 4. After installing and connecting the units, check all gas connec-tions to make sure they are tight. Soap solution, leak detection spray etc. Do no

7 Starting When operating units, the respective and relevant local guidelines must be observed. You must also observe these additional instructions:

8 Safety Mechanism Should overheating occur, the safety temperature lim-iter (STB) interrupts the gas supply and locks the unit’s electrical system.

9 Adjustment instructions: Dimension A = Distance from the tip of the ignition elec-trode to the bottom of the burner. Dimension B = Distance from the