Issue GB - W06REMKO RXS HRXS 261 H, RXS 351 H, RXS 521 H, RXS 681 H, RXS 1200 HCombined - outdoor componentsOperation · Technology · Spare parts
The outdoor component can be installed both inside and outside buildings. In the case of outdoor installation, please follow the instructions given b
Ensure a continuous and unobstructed air flow from outside, preferably using sufficiently large air intakes. Comply with any regulations and conditio
8. Remove the factory-fitted protective caps and union nuts on the stop valve connections. These should be used during installation.9. Before flangin
Tightness checkOnce all the connections have been established, the pressure gauge station is attached as follows to the Schrader valve (if fitted):red
Electrical connection diagram4. Feed both cables through the edge protection rings on the fixed connection panel.5. Terminate the cables as shown on
Electrical circuit diagramAfter the tightness check has been successfully completed, connect the vacuum pump via the pressure gauge station to the val
Add refrigerantThe unit contains a basic quantity of refrigerant. Additional refrigerant may be required depending on the indoor unit used. The revis
Functional test of the indoor unit and all program sequences. Check of the surface temperature of the suction pipe and determination of vaporiser
REMKO RXS H18RXS 261H / RXS 351HWe reserve the right to modify the dimensions and constructional design as part of the ongoing technical development p
Product illustration61245Spare parts listWhen ordering spare parts, please state the computerised part no., unit number and type (see identification pl
Subject to technical modifications, no responsibility taken for the correctness of information!ConsultancyIntensive training means our consultants are
ContentsThese operating instructions should be read carefully prior to commissioning / operation of the equipment!These instructions are part of the
Safety notesCarefully read this manual before starting the unit for the first time. It contains useful tips, information as well as hazard warnings t
The equipment is shipped in sturdy transport packaging. Immediately check the equipment on delivery and make a note of any damage or missing parts on
Combinations Cooling / heatingRXS261HRXS351HRXS521HRXS681HRXS 1200HRXW 261•RXW 351•RXW 521•RXW 681•RXD 260•RXD 350•RXD 520•RXD 680•RXD 1200•RXT 350•RX
The outdoor component is operated using the regulator for the indoor unit.The chapter on "Operation" in the manual for the indoor unit must
Fault Possible cause Checks Remedial measuresThe unit does not start or switches itself off.Power outage, undervoltageAre all electrical installations
Installation instructions for qualified personnelImportant points prior to installation Observe the manuals for the indoor unit and outdoor component
Comments to this Manuals